OEM 2004 Toyota Sienna Wheel Stud

2004 Toyota Sienna Parts Questions & Experts Answers

• Q: How to replace a Wheel Stud on the Rear Axle LH on 2004 Toyota Sienna?

  A: Begin the replacement of the Rear Axle LH Wheel Stud by first removing the rear wheel then disconnecting the rear disc brake caliper assembly LH with 2 bolts. Proceed with removing the rear disc combined with the rear brake drum sub-assembly. Special Service Tool 09628-10011 along with a hammer handle or adequate replacement tool should be used to hold the hub & bearing assembly while removing the LH wheel stud. You should install a washer and a nut to a fresh bolt before using the hammer handle or equivalent tool for tightening the LH wheel stud according to the illustrated instructions. Finish by installing the brake drum sub-assembly after which put on the rear disc. Measure the torque on the 2 bolts attaching the rear disc brake caliper assembly LH to 88 Nm using 900 kgf-cm and 65 ft. lbs. torque settings; afterwards install the rear wheel reaching 103 Nm (1,050 kgf-cm, 76 ft. lbs).