OEM 2004 Toyota RAV4 Power Steering Pump

2004 Toyota RAV4 Parts Questions & Experts Answers

• Q: How to service and repair the power steering pump on 2004 Toyota RAV4?

  A: Start power steering pump service and repair operations by using Special Service Tool: 09249-63010 to clamp down the drive belt tensioner bracket clockwise while removing the RH engine under cover and drive belt. Start by removing the suction hose through snap clip removal without permitting fluid to fall onto the drive belt. First disconnect the pressure feed tube through the removal of the union bolt with gasket before removing the oil pressure switch connector. To unfasten the PS vane pump assembly employ Special Service Tool: 09249-63010 but remember that bolt A cannot be fully removed before taking out bolt B and the pump assembly. You should use Special Service Tool: 09245-63010 to torque mounting bolts of the PS vane pump assembly at 30 Nm (305 kgf-cm, 22 ft. lbs.) while using a torque wrench with a 345 mm (13.58 inch) fulcrum length for installation. Scarce the pressure switch connector while avoiding oil contact and then join the pressure feed tube to the union bolt using a new gasket before tightening the bolt to 51.5 Nm (525 kgf-cm, 38 ft. lbs.). After securing the suction hose to its clip you should utilize Special Service Tool: 09249-63010 to compress the drive belt tensioner before turning it clockwise for at least 3 seconds before final installation. Finishing the job requires under-cover installation of the RH engine and power steering system bleeding procedures.