Other Name: Belt Assembly, Rear Seat; Seat Belt Lap and Shoulder Belt, Rear Left Outer, Rear Right Outer; Outer Belt Assembly; Rear Seat 3 Point Type, Outer Passenger & Driver Side.
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
More Info
Fits the following 2004 Toyota Prius Submodels:
Base, Touring | 4 Cyl 1.5 L FULL HYBRID EV-GAS (FHEV)
2004 Toyota Prius Seat Belt
Looking for affordable OEM 2004 Toyota Prius Seat Belt? Explore our comprehensive catalogue of genuine 2004 Toyota Prius Seat Belt. All our parts are covered by the manufacturer's warranty. Plus, our straightforward return policy and speedy delivery service ensure an unparalleled shopping experience. We look forward to your visit!
2004 Toyota Prius Seat Belt Parts Q&A
Q: How to replace the front seat belt on 2004 Toyota Prius?
A: The front seat belt replacement process starts with removing the front door scuff plate RH and the rear door scuff plate RH and the front door opening trim Weather Strip RH and the rear door opening trim Weather Strip RH together with the center pillar garnish lower RH and center pillar garnish RH. Start the seat belt pretensioner removal operation at least 90 seconds following battery disconnect and switching off the power source. Perform this step when removing the front seat outer belt assembly RH. Remote the pretensioner connector after which remove the 3 bolts and outer belt from its housing. The procedure requires the removal of the front shoulder belt anchor adjuster assembly by extracting its two bolts then carrying out the front seat inner belt assembly RH removal requiring front seat disassembly and bolt deletion. The front seat inner belt assembly RH requires installation through the nut followed by torquing it to 42 Nm (428 kgf.cm, 31 ft.lbf) and then the front shoulder belt anchor adjuster assembly gets installed through the 2 bolts with a correct torque of 42 Nm (428 kgf.cm, 31 ft.lbf). When evaluating the Front Seat Outer Belt Assembly RH retractor keep the unit intact and inspect its angle so the belt unlocks when the inclination remains under 15° and locks if it surpasses 45°. The outer belt assembly requires two bolts to be installed while the upper bolt reaches 5.0 Nm (51 kgf.cm, 44 in.lbf) torque and the lower bolt requires 42 Nm (428 kgf.cm, 31 ft.lbf). Reconnect the pretensioner connector then install the floor anchor cover before implementing a bolt connection between the shoulder belt anchor and the shoulder belt anchor adjuster with 42 Nm (428 kgf.cm, 31 ft.lbf) torque specification. Caulking and fixing both the front pillar garnish upper and center pillar garnish lower requires a floor panel nut torqued to 42 Nm (428 kgf.cm, 31 ft.lbf). The procedure ends with front and rear door scuff plate reinstallation and front and rear door opening trim Weather Strips installation. Then pull the belt quickly to check the ELR locks. Finally, reconnect the negative battery terminal and verify the SRS warning lamp. The negative (-) battery terminal reconnection should be followed by system initialization according to specified procedures.