OEM 2004 Scion xB Wiper Motor

2004 Scion xB Wiper Motor Parts Q&A

• Q: How to replace the windshield wiper motor on 2004 Scion xB?

  A: Starting the replacement process requires users to first take off the windshield wiper arm cover then eliminate front wiper arm and blade assemblies from the right side and left side. Detach the hood to cowl top seal by using a clip remover to remove its 5 clips. Use a clip remover to remove the four clips then disable five claws on each cowl top ventilator louver located on the right and left sides. To proceed with the windshield wiper motor and link assembly replacement start by disconnecting the connector after which remove the assembly along with the 3 bolts. The windshield wiper motor assembly needs a screwdriver to unfasten its two rods at the crank arm pivot points using tape on the screwdriver tip for protection then remove the three bolts. Affix the new windshield wiper motor assembly with its 3 bolts while applying a torque of 5.4 Nm (55 kgf.cm, 47 in.lbf) and apply MP grease to the crank arm pivot and reattach the 2 rods. After installing the 3 bolts onto the windshield wiper motor and link assembly torques reach 5.4 Nm (55 kgf.cm, 47 in.lbf). Finish the repair by reconnecting its connector. To install the left-side front wiper arm and blade assembly properly place the wiper in automatic stop position while removing the serration from the wiper arm before cleaning the wiper pivot serration point and tightening the nut at 20 Nm (205 kgf.cm, 15 ft.lbf) at position marks from 25 to 40 mm (0.98 to 1.57 in.). To verify the wiping performance check the rear wiper action through a spray of water or washer fluid until the wiper clears the vehicle's shape properly. Perform the same wiping procedure on the right front wiper assembly before fastening the nut to 20 Nm (205 kgf.cm, 15 ft.lbf) at the specified installation point between 29 to 44 mm (1.14 to 1.73 in.).