×
ToyotaParts- Hello
- Login or Register
- Quick Links
- Live Chat
- Track Order
- Parts Availability
- RMA
- Help Center
- Contact Us
- Shop for
- Toyota Parts
- Scion Parts
My Garage
My Account
Cart
OEM 2004 Scion xB Knock Sensor
Engine Knock Sensor- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Knock Sensor found
Product Specifications- Other Name: Sensor, Knock Control; Ignition Knock (Detonation) Sensor
- Manufacturer Note: DENSO
- Replaces: 89615-52040
- Part Name Code: 89615
- Item Weight: 0.70 Pounds
- Item Dimensions: 3.7 x 1.8 x 1.3 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 89615-52030
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
2004 Scion xB Knock Sensor
Looking for affordable OEM 2004 Scion xB Knock Sensor? Explore our comprehensive catalogue of genuine 2004 Scion xB Knock Sensor. All our parts are covered by the manufacturer's warranty. Plus, our straightforward return policy and speedy delivery service ensure an unparalleled shopping experience. We look forward to your visit!
2004 Scion xB Knock Sensor Parts Q&A
- Q: How to replace the Knock Sensor on 2004 Scion xB?A: Replacing the Knock Sensor requires the engine coolant drainage followed by air cleaner assembly separation and accelerator control cable disconnection. Start by taking off the transmission oil level gauge sub-assembly and transmission oil filler tube sub-assembly that belong to the A/T transaxle but then separate the throttle body assembly while disconnecting the ISC valve connector along with the throttle position sensor connector (for M/T transaxle) followed by removing the wire harness clamp and the bolt and two nuts which unmount the accelerator control cable bracket and throttle body and finally remove the gasket from the intake manifold. After removing the four nuts from the cylinder head cover No.2 follow these steps: disconnect the radiator hose inlet, remove the oil level gauge sub-assembly, detach the ventilation hose and union to connector tube hose, and then lose three wire harness clamps before removing the three bolts and two nuts in the specified sequence and the gasket from the intake manifold. To install the new knock sensor the Special Service Tool: 09816-30010 must be used to separate the sensor from its connector but torque it to 44 N.m (450 kgf.cm, 32 ft.lbf) when replaced. Install the intake manifold with new gasket while mounting three bolts and two nuts even throughout with a torque of 30 N.m (306 kgf.cm, 22 ft.lbf), attain the three wire harness clamps before reuniting the union to connector tube hose and ventilation hose. Install the oil level gauge sub-assembly following the connection of the radiator hose inlet before proceeding with cylinder head cover No.2 installation where you must tighten nut A first then nut B to 7.0 Nm (71 kgf.cm, 62 in.lbf). The new throttle assembly gasket needs installation first before securing its bolt and two nuts to 30 N.m (306 kgf.cm, 22 ft.lbf) throughout. Keep the wire harness clamp positioned and reconnect the throttle position sensor connector for (M/T transaxle) and ISC valve connector. The last sequence includes the installation of the A/T transaxle's transmission oil filler tube sub-assembly and transmission oil level gauge sub-assembly followed by accelerator control cable assembly, air cleaner assembly, engine coolant addition with leak detection methodology.