Q: How to replace the Antenna Cable Sub-Assembly on 2003 Toyota Camry?
A: To replace the Antenna Cord Sub-Assembly, begin by removing the front door scuff plates (LH and RH), cowl side trim sub-assemblies (LH and RH), instrument panel coin box sub-assembly, instrument panel upper sub-assembly, instrument panel insert sub-assembly lower LH (TMMK made), air conditioner control assembly, instrument cluster finish panel sub-assembly center, instrument panel under cover sub-assembly No.1, glove compartment door pad, instrument panel lower sub-assembly, floor shift lever knob sub-assembly (M/T transaxle), console panel upper rear, console box carpet, rear console box, instrument panel cup holder tray (without ashtray), instrument panel ash receptacle assembly (with ashtray), console panel upper, console box front, instrument panel finish panel lower center, front seat track covers (LH and RH rear outer and inner, TMC made), front seat assemblies (LH and RH, power and manual), rear seat cushion assembly, rear side seat back assemblies (RH and LH, TMC and TMMK made), rear seat back assemblies (RH and LH), roof side garnish inner (RH and LH, with and without curtain shield air bag), room partition board assemblies (TMMK and TMC made), package tray trim panel assemblies (TMMK and TMC made), rear seat shoulder belt cover (RH), rear seat 3-point type belt assemblies (outer and inner with center belt, TMC and TMMK made), and air duct rear No.2. The antenna cord sub-assembly removal process requires the nut and two bolts to be unscrewed while also disconnecting connectors and releasing clamps until the assembly can be taken out. Begin the reinstallation by placing the rear seat inner with center belt assembly (RH and LH, TMC and TMMK made) before you install the rear seat 3-point type belt assembly (outer, TMC and TMMK made). Following that install the rear side seat back assemblies (LH and RH, TMC and TMMK made), then finish with the front seat assemblies (LH and RH, power and manual).