Other Name: Belt Assembly, Rear Seat; Seat Belt Receptacle, Center Right; Latch; Belt Assembly, Rear Seat, Inner Passenger Side
Manufacturer Note: OAK,TRIM4#
Position: Inner Passenger Side
Part Name Code: 73380C
Item Weight: 1.40 Pounds
Condition: New
Fitment Type: Direct Replacement
SKU: 73380-0C020-E0
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
More Info
Fits the following 2002 Toyota Sequoia Submodels:
Limited, SR5 | 8 Cyl 4.7 L GAS
| Page 1 of 2 |Next >
1-20 of 23 Results
2002 Toyota Sequoia Seat Belt
Looking for affordable OEM 2002 Toyota Sequoia Seat Belt? Explore our comprehensive catalogue of genuine 2002 Toyota Sequoia Seat Belt. All our parts are covered by the manufacturer's warranty. Plus, our straightforward return policy and speedy delivery service ensure an unparalleled shopping experience. We look forward to your visit!
2002 Toyota Sequoia Parts Questions & Experts Answers
Q: What are the essential steps to inspect and repair the seat belt system after a collision on 2002 Toyota Sequoia?
A: A thorough examination of the seat belt system follows collisions because the entire assembly including outer belt and inner belt along with bolts and nuts and sill-bar requires replacement after facing any severe impact even without apparent damage. If the seat belt pretensioner fails to activate the technician must perform diagnostic checks while inspecting the center pillar lower garnish for cuts and cracks and marked discoloration and wire harness for damage along with connector chipping. The correct front seat outer belt removal and installation procedure must be followed. A diagnostic system check becomes necessary when pretensioner activation occurs because both the center pillar structure and the connector together with wire harness must undergo a visual inspection for damage. The seat belt pretensioner requires replacement under all of these conditions: activation, faulty diagnosis results or front seat outer belt malfunction and when front seat outer belts have been dropped. The correct procedure must be used for taking out and putting in the side and curtain shield Air Bag sensor assembly.