OEM 2000 Toyota MR2 Spyder ABS Control Module

2000 Toyota MR2 Spyder Parts Questions & Experts Answers

• Q: How to service and repair the ABS Control Module for Antilock Brakes on 2000 Toyota MR2 Spyder?

  A: Start services and repairs of the Antilock Brake Hydraulic Control Assembly by removing both the tool box and luggage compartment trim box cover. The ABS actuator brake lines become disconnected using Special Service Tool: 09023-00100 to separate the 6 brake lines from each other. The first step includes disconnecting 2 harness clamps then 2 actuator connectors leading to removal of the 2 bolts, the ABS actuator assembly along with its nut and subsequent removal of the 2 holders and 3 cushions from the ABS actuator. Begin by attaching two holders followed by three cushions onto the ABS actuator before installing the actuator to the actuator bracket using two nuts while tightening them to 5.4 Nm (55 kgf-cm and 48 inch lbs.). Use 2 bolts together with a nut to install the ABS actuator assembly where torques should be set to 19 Nm (195 kgf-cm, 14 ft. lbs.). Reinstall the 2 harness clamps and 2 actuator connectors. Use Special Service Tool: 09023-00100 for brake line installation on the ABS actuator setting torque to 15 Nm (155 kgf-cm, 11 ft. lbs.) and 14 Nm (143 kgf-cm, 10 ft. lbs.) at the specified torque points when using the special tool by selecting a torque wrench with a 30 cm (11.81 inch) fulcrum length. You should apply brake fluid to the reservoir before conducting a brake system bleed to make sure there is no fluid leak present. The last step includes reinstallation of the tool box and luggage compartment trim box cover.