OEM 2000 Toyota Celica Air Bag Control Module

2000 Toyota Celica Air Bag Control Module Parts Q&A

• Q: How to Service and Repair the Air Bag Control Module on 2000 Toyota Celica?

  A: The procedure to service and repair the Air Bag Control Module starts with Package Tray Trim Panel then follows with Rear Seat Back Assembly LH and RH and continues through Rear Seat Cushion Assembly then moves to Deck Trim Rear Cover along with Deck Trim Side Cover and ends with Deck Trim Side Panel followed by Luggage Compartment Tray proceeding to Rear Seat Back Hinge and completes with Quarter Trim Panel removal. The Side Air Bag Sensor Assembly requires removal by first you must discard the cover then eliminate the connector (handle the connector together with the sensor assembly installed) and free all 3 nuts. During installation only use new SRS parts because any components in collision should remain unused and the sensor must not undergo attempts at repair. Secure the Side Air Bag Sensor into place with three screws that need 20 Nm (205 kg.cm, 15 ft.lb) torque to be set. Then, attach the sensor connector when the installation of the sensor assembly is complete while confirming that the sensor remains secure and without damage. Test the sensor assembly stability through a shake of the assembly after completing SRS wiring installation to verify proper functionality. Install the cover first and afterward install the Quarter Trim Panel then the Rear Seat Back Hinge with 7.8 Nm (80 kg.cm, 69 in.lb) torque. To complete the repair the technician should reattach the Luggage Compartment Tray followed by the Deck Trim Side Panel, Deck Trim Side Cover, Deck Trim Rear Cover and finally install Rear Seat Cushion Assembly, Rear Seatback Assembly LH and RH using 18 Nm torque (185 kg.cm and 13 ft.lb) and finish installation with Package Tray Trim Panel.