Toyota 68160-52080
Belt Weatherstrip, Outer Passenger Side

The replacement process for the REAR DOOR GLASS Weather Strip ASSY OUTER LH starts by taking off the REAR DOOR REAR GUIDE BRACKET GARNISH LH followed by the POWER WINDOW REGULATOR SWITCH ASSY REAR and the REAR DOOR TRIM BOARD SUB-ASSY LH. Start by taking away the REAR DOOR INSIDE HANDLE SUB-ASSY LH and after that remove the REAR DOOR TRIM BRACKET N0.2 followed by the REAR DOOR SERVICE HOLE COVER RH. You should peel back protective tape from under the Weather Strip then use a moulding remover to pull out the REAR DOOR GLASS Weather Strip ASSY OUTER LH by taping the remover tip first.

The FIRST STEP to replace the OUTER FRONT DOOR GLASS Weather Strip ASSEMBLY requires removing the FRONT DOOR LOWER FRAME BRACKET GARNISH LH followed by the POWER WINDOW REGULATOR SWITCH ASSEMBLY and then the FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH. The following order to perform the replacement begins with removing the FRONT DOOR SERVICE HOLE COVER LH alongside the FRONT N0.2 SPEAKER ASSEMBLY (W/ TWEETER), followed by the OUTER REAR VIEW MIRROR ASSEMBLY LH. Use a moulding remover to remove the FRONT DOOR GLASS Weather Strip ASSEMBLY OUTER LH from the LH side of the front door that has a protective tape positioned under it to prevent damage followed by taping the remover tip before use. Procedures for installing the parts follow the opposite order of removal steps and apply equally to the RH side.

Remove the Rear Door Trim Bracket No.2.

Begin by removing the FRONT DOOR LOWER FRAME BRACKET GARNISH LH.