Toyota 68160-52040
Belt Weatherstrip, Outer Passenger Side

The installation process for the FRONT DOOR GLASS Weather Strip ASSEMBLY OUTER LH demands initial removal of FRONT DOOR LOWER FRAME BRACKET GARNISH LH after which users must detach DOOR PULL HANDLE, POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY, FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH, FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY LH, FRONT DOOR SERVICE HOLE COVER LH, and OUTER REAR VIEW MIRROR ASSEMBLY LH. You can extract the FRONT DOOR GLASS Weather Strip ASSEMBLY OUTER LH through protective tape placement under the Weather Strip combined with a moulding remover tool that requires tip taping before application. The installation possesses inverted procedures that mirror those of removal while operating identically on the RH side.

The replacement of the REAR DOOR GLASS Weather Strip ASSY OUTER LH requires the removal of door pull handle before power window regulator switch assembly for the rear followed by rear door trim board sub-assembly LH and rear door inside handle sub-assembly LH. The necessary steps begin by removing the LH side rear door trim board sub-assembly and the rear door inside handle sub-assembly LH. Begin the repair by taking away the rear door service hole cover LH from its position then remove the rear door glass Weather Strip assembly outer LH. Begin by placing protective tape under the Weather Strip and use a moulding remover to prise out the Weather Strip by taping the remover tip first. The process for installing components follows the exact opposite sequence of the uninstallation procedures while standard methods apply to both right-hand and left-hand installations.

The power window regulator switch assembly rear.

Begin by removing the FRONT DOOR LOWER FRAME BRACKET GARNISH LH.