Toyota 89742-42120
Transmitter

Additional RS3200 remote controls can be integrated through the procedures for programming new remotes to work with the default control scheme (Unlock two times for complete door release and no Auxiliary features for 4-button remotes) after which users can access the REMOTE CONTROL FUNCTION SELECT process. The procedure to clear all remote control codes allows reprogramming while new remote controls will support default operation mode functions. The REMOTE CONTROL FUNCTION SELECT procedure becomes necessary to change operation modes. Existing programed remote controls require a command through the REMOTE CONTROL FUNCTION SELECT process to modify default unlock settings for all door simultaneous unlocking with the UNLOCK button along with enabling AUX button use on 4 button remotes. Evacuation of all programmed remote controls requires following the procedure to enable subsequent new remote control programming. Users must use the procedure to modify the RS3200 passively arm setting along with entry delay time adjustments. The RS3200 automatically locks doors during ON or START key positions when all doors are sealed but the feature must be altered through following a procedure. Users must follow procedure instructions to alter either passive arming settings or entry delay time on RS3200 PLUS because this system defaults to not permitting passive arming during operation.

The RS3200 system supports up to four remote controls but requires programming the new device to default operation mode by pressing UNLOCK twice for unlocking all doors and disabling AUX button function on 4-button remotes; to select different operation modes use REMOTE CONTROL FUNCTION SELECT. A full procedure exists to eliminate existing remote control codes with reprogramming capabilities which also enables default operation mode function for new remote controls; users can modify operation mode functionality using the REMOTE CONTROL FUNCTION SELECT procedure. The default unlock operation mode and AUX button function activation for 4 button remote controls can be modified through the REMOTE CONTROL FUNCTION SELECT procedure when working with already programmed remote controls. You can clear all remote controls from operating the system by following the provided instructions while new remote control programming requires users to follow the reprogram procedure. You must execute the procedure to modify the disabled passive arming feature on the RS3200 while adjusting the entry delay duration. When all doors close the RS3200 operates according to factory settings by locking vehicle doors during ignition key ON or START and unlocking them when moving the key to ACC or LOCK positions. This feature's operation mode can be changed through a specific procedure. Users need to perform the same procedure for both adjusting RS3200 PLUS entry delay time and changing the system's operation for passive arming status.

No, the RS3200 is factory set to not passively arm; to change this setting and adjust the entry delay time, follow the appropriate procedure.

Follow the same default operation mode as above and use the REMOTE CONTROL FUNCTION SELECT procedure to change the mode.

The RS3200 is factory set to not passively arm.