Toyota 86101-06241
Antenna Cable

Repeat similar procedures for the Power Seat.

The navigation antenna cord is responsible for receiving signals to ensure accurate location tracking and navigation functionality.

Remove the instrument cluster finish panel, combination meter assembly (for TMC Made and TMMK Made), front door scuff plate RH, cowl side trim sub-assembly RH, instrument panel No. 2 under cover sub-assembly, lower instrument panel sub-assembly (for TMC Made and TMMK Made), shift lever knob sub-assembly (for both Automatic and Manual Transaxle), instrument cluster finish panel garnishes, floor shift position indicator housing sub-assembly (for Automatic Transaxle), upper console panel (for Manual Transaxle), upper console rear panel sub-assemblies (for both Automatic and Manual Transaxle), upper console panel sub-assemblies (for TMC Made and TMMK Made), instrument panel No. 2 register assembly, radio receiver with heater control panel assembly (without Navigation System), navigation receiver with heater control panel assembly, console box pocket, console box carpet, console box assemblies (for TMC Made and TMMK Made), console box insert fronts (for TMC Made and TMMK Made), front pillar garnishes, instrument panel No. 1 register assembly, instrument panel No. 1 speaker panel sub-assembly, front No. 2 speaker assemblies (for both LH and RH sides), defroster nozzle garnishes, instrument panel safety pad assemblies (for TMC Made and TMMK Made), defroster nozzle ducts (for TMC Made and TMMK Made), defroster nozzle assemblies (for TMC Made and TMMK Made), heater to register ducts (for TMC Made and TMMK Made), and No. 2 antenna cord sub-assembly by disengaging the 6 clamps and clip.

Remove the Side No. 1 and Side No. 2 Defroster Nozzle Ducts, followed by the Defroster Nozzle Assembly and the No. 1, No. 2, and No. 3 Heater to Register Ducts for both TMC and TMMK Made vehicles.

Align the marking tape with the rear edge and secure it.

First, check if the double-sided tape is still adhesive; if not, apply new tape by removing the old tape, peeling the new tape without touching the adhesive, and aligning it with the markings on the roof headlining assembly before peeling off the backing. Install the antenna cord from the front of the vehicle, ensuring the taped part aligns with the roof headlining's protrusion, and secure it with tape.