Toyota 46410-0R010
Front Cable

The first step to remove the parking brake cable begins with the removal of the rear console box sub-assembly based on procedures for extracting the No. 1 console upper panel garnish. The following task requires removal of the center Air Bag sensor assembly. You must first slacken the lock nut and No. 1 wire adjusting nut. You need to disconnect the three cable ends before taking away the parking brake equalizer. Remove the rear wheel and afterward disconnect the propeller shaft combined with the center bearing shaft assembly. Begin parking brake cable removal by first detaching cable clamp (A) from both the phone liner and vehicle frame followed by casing cap bolts (B) removal from the frame itself. The next step involves removing clamp bolts (C) from both the vehicle body and the crossmember and the trailing arms (E) along with F) from the crossmember and trailing arms respectively. The last step includes disconnection of parking brake cables from backing plates by first removing cable bolts then disconnecting cables from shoe levers and backing plates.

Begin by removing the rear console box.

Secure the cable to the backing plate with a bolt, torqued to 8.0 Nm (82 kgf-cm, 71 in-lbf).

Install the clamps to the trailing arms with the clamp bolts (labeled F) at a torque of 6.0 Nm (61 kgf-cm, 53 in-lbf), ensuring they are securely installed.