Other Name: Bulb; Turn Signal & Parking Light Bulb, Front; Car Bulbs; Signal Lamp Bulb; Signal Bulb; Exterior Bulbs; Bulb, Front Turn Signal & Parking Lamp; Bulb (For Front Turn Signal Lamp)
Manufacturer Note: 12V 30/8W
Position: Front
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Fits the following Vehicles:
2009-2015 Toyota Venza | Base, LE, Limited, XLE | 4 Cyl 2.7 L GAS, 6 Cyl 3.5 L GAS
Other Name: Bulb; Turn Signal & Parking Light Bulb, Front; Daytime Running Light Bulb; Car Bulbs; Signal Lamp Bulb; Front Turn Signal & Parking Lamp Bulb.
Position: Front
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Fits the following Vehicles:
2013-2015 Toyota Venza | LE, Limited, XLE | 4 Cyl 2.7 L GAS, 6 Cyl 3.5 L GAS
Other Name: Bulb; Center High Mount Stop Light Bulb; Back Up Light Bulb; Tail Light Bulb; Turn Signal Light Bulb; Fog Light Bulb; Bulb & Socket; Various types of exterior and signal bulbs for vehicles.
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Fits the following Vehicles:
2009-2015 Toyota Venza | Base, LE, Limited, XLE | 4 Cyl 2.7 L GAS, 6 Cyl 3.5 L GAS
Toyota Venza Headlight Bulb
If you're thinking about purchasing OEM parts for your Toyota Venza, our website is your one-stop destination. We stock an extensive selection of genuine Toyota Venza Headlight Bulb at pocket-friendly prices. Plus, we guarantee a swift delivery and a hassle-free return policy for your convenience.
Q: How to remove the High Intensity Discharge headlight bulb on Toyota Venza?
A: Removing the High Intensity Discharge headlight bulb requires that the negative battery terminal be disconnected and left to wait 90 seconds. Swap the old gasket by taking off the back cover of the headlight, and fitting in a new one. Lastly, loosen the socket of the light control ECU, spring it and take out the bulb without touching the glass.
Q: How to install the high intensity discharge headlight bulb on Toyota Venza?
A: Installation of the high intensity discharge headlight bulb requires that the set spring should be locked without touching the glass surface of the bulb followed by the connection of the light control ECU socket. Install headlight gasket, screw on the No. 1 headlight back cover and reattach the negative battery terminal, with possible initialisation required.