OEM Toyota Solara Blower Motor

Toyota Solara Blower Motor Parts and Q&A

• Blower Motor
  87103-06031
  Q: How to remove the blower motor on Toyota Solara?

  A:

  Commence by uninstalling the safety pad from the instrument panel before moving onto the heater to foot duct No.1. First separate the stereo component amplifier assembly and set aside the ECM by using proper procedures for Engine Control Modules 2AZ-FE and 3MZ-FE. Begin by disconnecting all connectors from the blower assembly after removing its screw and clamp together with the blower connector holder followed by disconnecting five wire harness clamps. The two wire harness clamps should be detached from stereo component amplifiers on vehicles that have such systems installed. The removal procedure requires manual A/C models to detach their four connectors along with removing the clamp whereas auto A/C models require disconnecting their three connectors and removing the clamp. To end the procedure you should take off both screws along with two nuts and the blower assembly. The installation procedure follows the opposite sequence of the removal steps.
• Blower Motor
  87103-06041
  Q: How to install a blower motor and its related components on Toyota Solara?

  A:

  The blower assembly must be fastened using two screws and two nuts where the nut torque should reach 1.5 Nm (15 kgf-cm, 12 in-lbf). The manual A/C model needs four connectors but the automatic A/C model requires three connectors to be joined after clamp installation. The installation of 2 wire harness clamps should precede the installation of 5 wire harness clamps only if the vehicle has a stereo component amplifier assembly installed. The blower connector holder can be attached through screw and clamp installation before connector connection. The last step involves setting up the instrument panel safety pad.