The installation of the audio/video luggage speaker starts with the w/box No. 1 speaker assembly that requires 4 bolts torqued to 7.0 Nm (71 kgf-cm, 62 in-lbf) and needs connector connection. The quarter side speaker assembly RH requires two bolts installation followed by torque setting at 7.0 Nm (71 kgf-cm, 62 in-lbf). Then engage the guide tab and connect the connector. The installation of quarter side speaker assembly LH requires two bolts and connector connection. Follow these next steps to install the rear window No. 2 side garnish assembly RH and LH while considering that power back doors have different installation requirements. The quarter trim panels must be installed on both sides for standard as well as power seat vehicles. Continue the installation by adding rear floor mat support plate, rope hook assembly, rear door opening trim Weather Strips both for RH and LH sides, along with the rear door scuff plates for both RH and LH sides and the rear floor step covers No. 1 and No. 2 and the rear seat cushion hinge lower covers for the RH and LH sides. Rephrase both the rear No. 2 seat assembly RH and LH based on the detection of manual or power seat setup. The deck board bracket installation process should be followed by the addition of deck board reinforcement sub-assembly, No. 1 deck board sub-assembly and luggage compartment trim box before proceeding with No. 2 deck board sub-assembly installation.