Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Fits the following Vehicles:
2004-2006 Scion xB | Base | 4 Cyl 1.5 L GAS
Scion xB Brake Line
If you're thinking about purchasing OEM parts for your Scion xB, our website is your one-stop destination. We stock an extensive selection of genuine Scion xB Brake Line at pocket-friendly prices. Plus, we guarantee a swift delivery and a hassle-free return policy for your convenience.
Scion xB Brake Line Parts Questions & Experts Answers
A: The installation of the front flexible brake hose requires a union bolt attached to both the new gasket where proper torque reaches 29 Nm (296 kgf-cm, 21 ft-lbf). Fasten the flexible hose properly to its designated lock hole on the disc brake cylinder. Use two bolts to fasten the absorber bracket to the flexible hose and speed sensor bracket in order to reach 29 Nm (296 kgf-cm, 21 ft-lbf) torque requirements while inserting the flexible hose initially. The new clip should be fitted to the front brake flexible hose after orientation of its identification mark facing away from the vehicle interior during hose untwisting. Fully push the clip until it reaches its maximum position. The installation requires placing the brake tube onto the flexible hose with a union nut wrench and maintaining hose contact by using another wrench; torque the connection to 14 Nm (143 kgf-cm, 10 ft-lbf) through the nut wrench or 15 Nm (155 kgf-cm, 11 ft-lbf) without it. A 300 mm (11.8 in.) torque wrench with a parallel union nut wrench of 22 mm (0.886 in.) fulcrum length allows the operator to reach a secure torque. During the final installation sequence, start by filling the brake fluid reservoir followed by cylinder and brake line bleeding until the actuator is also bled. Then check the reservoir fluid level, examine for fluid leaks before installing the front wheel with a torque of 103 Nm (1050 kgf-cm, 76 ft-lbf).