OEM 2009 Toyota FJ Cruiser Wiper Motor

2009 Toyota FJ Cruiser Wiper Motor Parts Q&A

• Q: How to install the rear wiper motor and assemble the rear wiper arm and blade on 2009 Toyota FJ Cruiser?

  A: The rear wiper motor must be fastened to position using 3 bolts while maintaining 5.5 Nm of torque (56 kgf-cm, 49 in-lbf) and then connecting the wiring. The rear wiper arm and blade assembly requires cleaning of the serrated wiper arm segment using a round file until all metal powder is gone and subsequent wiping of wiper pivot serrations with a wire brush. The windshield wiper motor requires automatic stop position activation before placing the rear wiper arm in its correct position using the nut which should be torqued to 5.5 Nm (56 kgf-cm, 49 in-lbf). You should position the rear wiper arm slider 20 mm below its rise-up position when tightening the wiper arm in rotational sequence before raising the slider to the up position and covering the rear wiper arm head cap. To complete the door installation proceed with inserting the back door service hole cover followed by the back door trim board and door trim retainer cap before setting the back door trim cover LH and back door trim cover RH. To finish the procedure hook up the cable to the negative battery terminal while tightening it at a torque of 3.9 Nm (40 kgf-cm, 35 in-lbf).