OEM 2008 Scion tC Ball Joint

2008 Scion tC Parts Questions & Experts Answers

• Q: How to install the front lower ball joint assembly LH on 2008 Scion tC?

  A: First install the lower ball joint LH onto the steering knuckle by applying the castle nut while clearing oil from the thread and taper then torque it to 103 Nm (1,050 kgf-cm, 76 ft-lbf). The replacement cotter pin requires additional 60-degree nut tightening when the holes do not line up properly. The workers will install the front axle assembly LH then proceed with the front suspension No. 1 lower arm sub-assembly LH. The next step is to install the tie rod end sub-assembly LH. To complete the installation you should put on the front speed sensor LH followed by the front axle shaft LH nut. The technician must attach the front wheel followed by torquing it to 103 Nm (1,050 kgf-cm, 76 ft-lbf) before inspecting the front wheel alignment to verify its accuracy and conducting a test for the ABS speed sensor signal performance.