Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
More Info
Fits the following 2005 Toyota Highlander Submodels:
Base, Hybrid, Hybrid Limited, Limited, Sport | 4 Cyl 2.4 L GAS, 6 Cyl 3.0 L GAS, 6 Cyl 3.3 L FULL HYBRID EV-GAS (FHEV), 6 Cyl 3.3 L GAS
2005 Toyota Highlander Wiper Blade
Looking for affordable OEM 2005 Toyota Highlander Wiper Blade? Explore our comprehensive catalogue of genuine 2005 Toyota Highlander Wiper Blade. All our parts are covered by the manufacturer's warranty. Plus, our straightforward return policy and speedy delivery service ensure an unparalleled shopping experience. We look forward to your visit!
2005 Toyota Highlander Wiper Blade Parts Q&A
Q: How to replace the rear Wiper Blade on 2005 Toyota Highlander?
A: Selection of new rear wiper rubber begins with removing the assembly by raising the blade until you hear the disengaging click while avoiding harming the claws. Draw the rear wiper blade in a single motion towards the left side of the automobile to unmount it from the arm which must stay upright. Put the rear wiper rubber out at the base end stopper of the rear wiper blade. Do this without using force because it could cause damage to either backing plates or blade claws. Pull the wiper rubber from its base area of maximum space while gently pushing the blade claw and nearby wiper area for better removal. Place the new rear wiper rubber inside the rear wiper blade through its claw position at the middle before guiding it toward the base end. Verify that the rubber extends from the base end stopper while also moving through the tip end claw after passing through the base end claw. To make sure the wiper blade claws properly fit into the rear wiper rubber groove people should slide the rubber several times while little window washer fluid can help achieve a proper fit. The wiper rubber should be stretched through sliding by lifting the center section while gentle motion prevents damage to either the backing plates or blade claw.