Toyota 62331-35020-B0
Surround Weatherstrip, Passenger Side

The process of servicing the Front Door Window Glass Weather Strip starts with removal of the Power Window Regulator Master Switch Assembly followed by the Front Door Lower Frame Bracket Garnish LH then Front Door Inside Handle Bezel LH followed by Front Armrest Assembly LH and Front Door Trim Board Sub-Assembly LH and Front Door Service Hole Cover LH before Outer Rear View Mirror Assembly LH and Front Door Window Frame Moulding Rear LH. The service requires removing the Front Door Glass Weather Strip Assembly Outer LH carefully by placing protective tape beneath it then removing the screw and disengaging the claw with a screwdriver or moulding remover. Begin installation by inserting the claw and screw into the Front Door Glass Weather Strip Assembly Outer LH before replacing other components such as the Front Door Window Frame Moulding Rear LH and remaining assembly pieces including the Outer Rear View Mirror Assembly LH and Front Door Service Hole Cover LH.

You need to start back door glass Weather Strip service by taking off the assist strap hole cover and removing the assist strap assembly RH before detaching the back door trim panel. Initial steps for servicing the back door glass Weather Strip include applying protective tape below the glass Weather Strip and using a screwdriver or moulding remover to loosen the claw while carefully removing the glass Weather Strip outer. The screwdriver tip must be taped and placed on both door glass Weather Strip edges. Start the installation by placing the claw on the glass Weather Strip outer before bringing back the back door trim panel assembly.

Place protective tape under the glass weatherstrip assembly, remove the screw, and use a screwdriver or moulding remover to disengage the claw and take out the glass weatherstrip, ensuring to tape the screwdriver tip before use.

The installation follows the reverse order of removal.

Detach the Outer Rear View Mirror Assembly LH and the Front Door Window Frame Moulding Rear LH.

The Rear Door Inside Handle Bezel LH, Rear Armrest Assembly LH, Rear Door Trim Board Sub-Assembly LH, and the Rear Door Window Frame Moulding Front LH.

You need to take off the assist strap hole cover, remove the assist strap assembly RH, and then remove the back door trim panel.

First, unscrew it, place protective tape under the glass weatherstrip, and use a screwdriver or moulding remover to disengage the claw for removal.

Place protective tape under the glass weatherstrip assembly, remove the screw, and use a screwdriver or moulding remover to disengage the claw and take off the glass weatherstrip, ensuring to tape the screwdriver tip before use.