Toyota 86160-52120
Tweeter, Passenger Side

The procedure to swap the Front No. 1 Speaker Assy starts by taking off the Front Door Lower Frame Bracket Garnish LH followed by the Power Window Regulator Master Switch Assy and then the Front Door Trim Board Sub-Assy LH. After connector detachment from the Front No. 1 Speaker Assy use a drill with less than 4 mm (0.16 in.) diameter to drill 3 rivet heads and separate the speaker from the front door panel while rotating the drill near the rivet head to cut flanges. Avoiding both the damage to rivet holes and drill bit breakage. Take precautions because the severed rivet will be warm so proceed with drilling until you remove all debris pieces. The procedure requires vacuum cleaning of the drilled rivet along with the interior front door panel dust. When installing the Front No. 1 Speaker Assy on the front door panel you should use an air riveter or hand riveter to add three new strike rivets according to the provided order illustration. The riveter requires operator care to prevent damage by not prizing it and by keeping it level to rivet at correct alignment. You must not break the tightened rivets from materials once they become securely fastened. Drop the rivet into place only when the materials have no space between them before reattaching the connector.

Reconnect the connector.

Only install the rivet when there is no clearance between the materials.