Toyota 69802-60080
Window Regulator, Driver Side

The first step to remove the rear door window regulator requires disconnecting the negative battery cable for at least ninety seconds so the SRS system can be fully disabled. You must separate the rear door inside handle bezel and also remove the rear door armrest base panel assembly and assist grip cover and rear door trim board sub-assembly followed by the rear inner door glass Weather Strip and rear speaker set then eliminate the rear door service hole cover and rear door glass run and rear door rear lower window frame sub-assembly and rear door quarter window glass and the last step is to disassemble the rear door glass sub-assembly. Use a T25 "TORX" driver to remove the 3 screws securing the motor on the rear power window regulator assembly along with its sub-assembly while preventing the motor from falling and sustaining damage.

The first step to remove the rear door window regulator requires disconnecting the negative battery cable then waiting 90 seconds to deactivate the SRS system. The first step includes removing the bezel inside the rear door handle and then proceeding with the base panel assembly of the armrest and assist grip and trim board. The process requires removal of the rear inner door glass Weather Strip and rear speaker set and the rear door service hole cover and rear door glass run. The service technician must first remove the rear door rear lower window frame sub-assembly as well as the rear door quarter window glass and the rear door glass sub-assembly. The removal of rear door window regulator sub-assembly and rear power window regulator motor assembly requires a T25 "TORX" driver to dislodge three motor mounting screws with extreme caution to avoid motor damage by dropping it.