Toyota 90975-02076
Emblem

The installation of emblem and rear body name plate and back door name plate starts with heating the vehicle body along with all components using a heat light while avoiding excessive heat damage to any components. Clean the body first followed by heating it with heat light before you remove the double-sided tape and wipe off residue with cleaner. Start by heating the existing vehicle body together with the new emblem. Once the emblem is ready, remove its peeling paper along with carefully arranging the boss locations before final placement. Rephrase this procedure for the rear body name plate by cleaning and heating its surface before removing tape for proper placement of the new plate while pressing it tight. The installation process for the back door name plate entails following the same heating and cleaning procedure then removing the peeling paper before putting it into position while providing firm pressure.

Apply protective tape around the emblem.

Install the emblem and then install the radiator grille using the 3 screws.

Clean and heat the surface, remove the tape, and install the new plate in the specified position, pressing it firmly.

Put protective tape around the back door name plate, insert a piano wire between the vehicle body and back door name plate, tie wooden blocks to both ends of the wire, pull the wire to scrape off the double-sided tape, and remove the back door name plate while ensuring the vehicle body remains undamaged.