Toyota 85130-52060
Wiper Motor, Rear

The procedure starts with back door trim board assembly removal to unveil the rear wiper arm. Subsequently, remove the wiper arm by unscrewing the nut and taking away the 2 claws. Disconnection of the connector should precede 3 bolt removal to extract the rear wiper motor assembly. The new rear wiper motor assembly needs to be positioned before tightening the 3 bolts to 5.5 Nm (56 kgf.cm, 49 in.lbf) torque value with connector reattachment. Install the rear wiper arm only after stopping the windshield wiper motor assembly at automatic stop then remove the serrated section from the wiper arm with a round file before using a wire brush to clean the wiper pivot serration. Install the rear wiper arm after positioning the nut correctly and tighten it to 5.5 Nm (56 kgf.cm, 49 in.lbf) under manual arm hinge restraint. Reinstall the back door trim board assembly.

Service of the rear wiper motor begins with disconnecting the cable from the negative battery terminal followed by a mandatory 90-second wait before starting to avoid Air Bag and seat belt pretensioner activation. First remove the back door trim board assembly then detach the rear wiper arm after opening the cover and unfastening the nut. You should disconnect the connector followed by the removal of three bolts to extract the rear wiper motor assembly. The wiper motor assembly should be attached through three bolts then torqued to 5.5 N.m (56 kgf.cm, 49 in.lbf) before reconnecting the connector. To install the wiper arm position the wiper until it stops at the automatic stop point then file off one side of the fragmentated component followed by wire brushing the wiper pivot while securing the wiper arm with a nut that has a torque of 5.5 N.m (56 kgf.cm, 49 in.lbf) at which time the arm hinge needs manual maintenance. The procedure requires reinstallation of back door trim board assembly followed by cable connection to the negative battery terminal before system initialization because some systems need battery cable disconnection and reconnection.

Remove the right front wiper arm and the hood to cowl top seal by disengaging the 8 clips with a clip remover.

Remove the clips and bolts, and detach the 5 claws on both the left and right sides.

Yes, repeat the same process for the front wiper arm & blade assembly RH.