Toyota 48202-0C010
Leaf Spring, Passenger Side

Remove the spring bumper.

Bend to open the spring clips and pry up the 2 spring clips with a chisel and hammer, then remove the center bolt and nut while holding the spring in a vise. Replace the spring clip by drilling off the head of the rivet and driving it out, then install a new rivet and secure it with a press. Reinstall the spring center bolt and nut, aligning the leaf spring holes and securing the leaves in a vise, and torque to 44 Nm (450 kgf-cm, 33 ft. lbs.). Bend the spring clips back into position with a hammer.

Detach the nut, washer, and bolt, then remove the 2 nuts, washers, bolts, shackle, and leaf spring.

Remove the 4 U-bolt mounting nuts and washers, followed by the spring seat and 2 U-bolts, and finally the spring bumper.

Tap out the outer tubes with a chisel and hammer.

Bend the spring clips back into position with a hammer.

Install the rear wheel, applying a torque of 110 Nm (1,150 kgf-cm, 83 ft. lbs.).