Toyota 56101-0T010
Windshield, Front

The installation of new windshield glass begins with applying Primer G onto 2 new No. 2 windshield glass stoppers, using moderation and waiting for at least 3 minutes before discarding excess primer. Place the stoppers onto the windshield glass followed by the installation of 2 No. 1 windshield glass stoppers to the vehicle body. The installation of 2 new windshield glass retainers demands treatment with Primer G on their application regions before following the same primer application procedures. Extending the new adhesive dam follows the correct position of the dam reference line. To install the windshield glass on vehicles without sliding roofs users must first apply suction cups that provide an even surface with proper alignment of matchmarks before removing the glass. The vehicle body requires coating of Primer M on the installation area except the adhesive zone before drying occurs. Apply Primer G first onto the adhesive area while focusing on the ceramic notches before using Toyota Genuine Windshield Glass Adhesive or equivalent on the glass by cutting the cartridge nozzle. The glass assembly should be installed by matching the marks while pressing the rim gently until the stoppers are properly positioned and the clearance area is checked. After the adhesive dries keep the glass in position with tape during the mentioned minimum downtime period while driving the vehicle is forbidden. Vehicle owners with sliding roofs must conduct their sliding roof fix procedure starting from correct positioning steps and moving towards primer application followed by adhesive application. There should be a leaking test conducted by spraying water onto the vehicle from outside after adhesive curing. If any leakage occurs you must allow drying until you can add more adhesive as required. Reinstall the roof headlining assembly and applicable components such as visor holders, assist grip sub-assemblies, visor assemblies, visor bracket covers, roof console box assembly, inner rear view mirror assemblies, front pillar garnishes, door opening trim Weather Strips, and cowl top ventilator louver sub-assembly and front fender to cowl side seals and front wiper arm and blade assemblies.

Proceed to remove the roof console box assembly, visor bracket covers, and visor assemblies for both sides.