Toyota 56101-06172
Windshield, Front

Primer G application begins the windshield glass installation process with the No. 2 windshield glass stoppers where minimal primer usage is required for at least 3 minutes of drying time before wiping away extra primer. After placing two new No. 2 stoppers on the windshield glass the installer must apply Primer G to the retainers before installing two new retainers. Afterwards you should position two new No. 1 stoppers to the vehicle body. A mixture of Primer G goes onto the moulding area followed by installation of a new moulding. When using the adhesive dam you should first apply Primer G to its installation area before the liquid dries while you install a fresh adhesive dam against the ceramic notches. Install the windshield glass assembly by using a suction cup on its contact surface and checking alignment of matchmarks before removing it. First apply Primer M to the vehicle body section where the adhesive will not be placed followed by Primer G application on the adhesive area especially around the ceramic notches. Use TOYOTA genuine windshield glass adhesive or equivalent and apply it within the prescribed period after cutting the cartridge nozzle. Place the windshield glass assembly while lining up the matchmarks and apply gentle pressure along the rim until the stoppers are in the correct position while checking the overall clearance. Slight pressure on the front side of glass requires the possible use of a scraper to modify the adhesive. Use adhesive or equivalent to secure the glass frame with protective covering before the adhesive reaches necessary hardness. Also avoid operating the vehicle during the minimum application time. Inspect the leaks by applying water from outside after adhesive curing. Additional adhesive may be necessary when leaks are detected before removing protective tape.

Begin the windshield glass installation by applying Primer G to No. 2 stoppers at their installation area and drying for 3 minutes before wiping off remaining primer. Put two new No. 2 stoppers on the windshield glass followed by coating the new retainers' application area on the windshield with Primer G using the same drying and excess removal process. Install the two standardized retainers. Attach 2 new type 2 stoppers to the vehicle body through the 2-part system. To install a new moulding on the windshield apply Primer G to the correct alignment area then place it in position when dry. Before placing a new adhesive dam over the notch areas, apply Primer G to the dam area and let it dry. Use a suction cup to position the windshield glass assembly before you take it away once it settles evenly against its matchmarks. Spread Primer M only on the vehicle surface that will accept components and wait for it to set. Use Primer G on ceramic notches and apply it to the adhesive site before installing TOYOTA genuine windshield glass adhesive or equal parts. Firmly put the windshield glass assembly in place when its matchmarks properly align and press the border evenly. Also check if stoppers are set correctly and the windshield meets air gap standards. Press gently on the front glass surface and use a scraper tool to alter adhesive application if needed. Keep the windshield in position with protective tape until the adhesive dries completely and refrain from operating the vehicle during the required time interval. Once adhesive cures examine it for defects by spraying from outside then let it dry before reinstalling the protective tape and adding more glue if needed when required leaks are located. Install the roof headlining besides other components including front assist grip and visor holder assemblies. Maintain the front door opening trim Weather Strips then complete the procedures by reattaching the power source terminal.

Disconnect the cable from the negative battery terminal.

Remove the window glass adhesive dam and the No. 2 windshield glass stoppers using a scraper, taking care not to damage the glass, and replace them with new ones.

Remove the No. 2 windshield glass stoppers (part number: 75310-0C010) and the windshield glass retainers (part number: 75320-0C010) with a scraper, and also remove and replace the No. 1 windshield glass stoppers (part number: 75330-0C010).

The cowl top ventilator louver sub-assembly, the inner rear view mirror assembly (without EC mirror), and the inner rear view mirror stay holder cover (with EC mirror).