Toyota 17140-38010
Manifold Assembly, Exhaust, Passenger Side

The first step to remove the exhaust manifold requires removal of the front fender splash shield sub-assembly LH and RH. The technician should start by eliminating both the No. 1 engine under cover sub-assembly and the No. 2 engine under cover. A clip remover helps remove 3 clips from the front fender apron seal front RH before extracting 4 clips from the rear RH part. Use the clip remover to detach all 3 and 4 clips on the LH components of front fender apron seal and rear LH before beginning. The maintenance sequence requires the deduction of the following components: Engine oil level dipstick guide, tailpipe assembly, center exhaust pipe assembly, front No. 2 exhaust pipe assembly and front exhaust pipe assembly. After taking out two propeller shaft heat insulator bolts proceed with removing the two bolts from the No. 2 manifold stay. The next step involves removing 3 bolts that secure the No. 2 exhaust manifold heat insulator before removing the exhaust manifold sub-assembly LH by taking off 10 nuts, the exhaust manifold and its accompanying 2 gaskets. The technician should remove the No. 1 manifold stay using 2 bolts followed by removing the No. 1 exhaust manifold heat insulator with 3 bolts. The exhaust manifold sub-assembly RH requires removal by first removing its insulator from the exhaust manifold then the 2 nuts followed by 10 nuts and both exhaust manifold gaskets.

Temporarily attach the exhaust manifold using the 2 nuts labeled A and 8 new nuts.

Remove the exhaust manifold sub-assembly LH by taking off the 10 nuts, exhaust manifold, and 2 gaskets.