Toyota 86101-0T011
Antenna Cable, Rear

When fitting the No. 3 antenna cord sub-assembly use the rear No. 2 washer hose to thread it through the assembly then through the vehicle body until you securely engage the 2 claws which brings the grommet into place at the back door. Subsequently attach all 4 clamps. The installation of the rear No. 2 washer hose requires 4 hooks for vehicles without Satellite Radio and includes the 2 connectors while vehicles with Satellite Radio require 3 connectors and proper positioning of the grommet which faces outside the vehicle. After this step engage the 6 clamps to install the satellite radio antenna cord while connecting the 2 connectors. Begin by screwing in the rear seat lock control lever sub-assembly and complete the installation with window panel trim and the back door panel trim assembly then the back door trim covers (RH and LH with or without Power Back Door). To install the No. 2 antenna cord sub-assembly join it with the rear No. 2 washer hose to the roof headlining assembly markers and secure it with tape while temporarily installed. Use packing tape when needed. The last step involves roof headlining assembly setup then 7 clamp installation to place the No. 1 antenna cord sub-assembly and final installation of the instrument panel safety pad assembly.

Remove the upper back window panel trim, back door panel trim assembly, and the back door trim covers for both left and right sides.