Toyota 86101-0R130
Antenna Cable, Rear

Begin antenna cable installation by mounting the No. 3 antenna cord sub-assembly using new double-sided tape at point A while aligning the antenna cord masking tape to the edge of the roof headlining and attaching the cord on the tape until reaching the surplus area before securing both ends with tape. Proceed with the antenna cable installation in the same manner for vehicles that contain sliding roofs. After installing the roof headlining assembly you should begin attaching the antenna cord sub-assembly through four clamps then join the connector. Proceed by installing the instrument panel sub-assembly upper before moving to the front pillar garnish LH and RH and the glove compartment door assembly followed by the instrument panel register assembly center. Installation of the navigation receiver assembly that includes a bracket should be performed immediately before installing the radio receiver assembly accompanied by its bracket. Install the instrument cluster finish panel sub-assembly along with a combination meter assembly and connect the cable to the negative battery terminal after which you will set both finish panels' center pieces.

Disconnect the connector, detach the four clamps, and remove the antenna cord.