Toyota 77035-02250
Release Cable, Rear

The initial step for removing the Fuel Lid Lock Control Cable Assembly starts by disconnecting the cable from the negative terminal of the battery while waiting at least 90 seconds to prevent SRS activation. When operating manual seats you need to take away the front seat headrest assembly together with the outer seat track cover and inner seat track cover and front seat assembly. When working on power seats first repeat the removal process of the front-seat headrest assembly as well as the outer seat track cover and the inner seat track cover and the front seat assembly. The next procedure requires removal of the front door scuff plate LH, cowl side trim board LH, front door opening trim Weather Strip LH and rear door scuff plate LH and rear door opening trim Weather Strip LH. Release the front seat outer belt assembly LH by removing its lap belt outer anchor cover and disconnecting it. The next step involves taking out the lower center pillar garnish LH along with the spare wheel cover and rear seat headrest assembly LH, and the three additional components that include rear seat cushion assembly, rear seatback assembly LH, and rear seat side garnish LH. Add the roof side inner garnish board LH, rear floor finish plate, and inner luggage compartment trim cover LH that require removing the 4 clips. The luggage door functionality needs to be disconnected by first removing the bolt from the open lever assembly before separating the lock control cable assembly which operates the luggage door open lever assembly. Follow the last step by disconnecting the fuel lid lock control cable sub-assembly which includes separate 2 claw and 7 clamp removal.

The fuel lid lock control cable sub-assembly needs to be installed by securing the 7 clamps and 2 claws before connecting it to the assembly. The next step involves wiring the fuel lid lock control cable assembly while using a bolt to secure the luggage door lock open lever assembly with a torque value of 5.5 Nm (56 kgf-cm, 49 in-lbf). Install the 4 clip fastened inner luggage compartment trim cover LH followed by the rear floor finish plate along with the roof side inner garnish board LH, rear seat side garnish LH, rear seatback assembly LH and rear seat cushion assembly. You should first install the rear seat headrest assembly LH and then set in the spare wheel cover. The next step involves placing the lower center pillar garnish on the left side followed by the front seat outer belt assembly connection on the left side and final installation of the lap belt outer anchor cover. Work on installing the rear door opening trim Weather Strip LH, rear door scuff plate LH, front door opening trim Weather Strip LH, cowl side trim board LH and front door scuff plate LH. Install the front seat assembly and inspect and enable the front seat slide adjuster lock before adding the inner and outer seat track covers followed by the front seat headrest assembly when using manual seats. Users must install front seat components such as the front seat assembly as well as inner and outer seat track covers before adding the front seat headrest assembly. Before testing the system it is essential to connect the cable to the negative battery terminal while checking both the SRS warning light and front seat assembly (for power seat).