Toyota 33820-0T010
Shift Control Cable

Start transmitting the U760F AUTOMATIC TRANSMISSION / TRANSAXLE control cable assembly by placing the park/neutral position switch and shift lever into neutral position. Pass the control cable from the cabin to the engine compartment before installing the No. 2 shift cable grommet retainer using 2 bolts which need to be torqued to 5.0 Nm (51 kgf-cm, 44 in-lbf). Pull the transmission control cable through the dash grommet into the engine compartment until complete cable insertion against the dash grommet occurs. The transmission control cable must have its outer end fastened by a nut torque setting at 13 Nm (130 kgf-cm, 9 ft-lbf) to join a new clip installed at the control shaft lever. The installation sequence requires the placement of the air cleaner case sub-assembly followed by installing the air cleaner filter element sub-assembly then the air cleaner cap sub-assembly followed by the inlet air cleaner assembly before the cool air intake duct seal and the instrument panel reinforcement assembly with the air conditioning unit are added. Inspect and readjust the shift lever position when needed as the last step.

The inlet air cleaner assembly, air cleaner cap sub-assembly, air cleaner filter element sub-assembly, and air cleaner case sub-assembly.