Toyota 73230-48210-B0
Buckle End, Gray, Driver Side GRAY

Check the retractor's inclination: if it is 15 degrees or less, the belt should pull from the retractor; if over 45 degrees, the belt should lock.

Install the separate type rear seatback cover with pad, rear seatback lock bezel upper, rear seat headrest support (two units), rear seat lock control lever sub-assembly, rear seatback lock striker cover, rear seat headrest assembly, rear seat belt assembly inner, separate type rear seat cushion assembly, rear seat cushion moulding rear LH, reclining hinge cover LH, vertical adjuster bracket cover LH, rear seat cushion moulding LH, center seatback assembly, seat track upper rail cover LH, center seat hinge cover upper RH, reclining cover protector RH, rear seatback board carpet assembly, rear seatback cover, tonneau cover hook holder, rear No.1 seat assembly LH, seat track cover inner LH, rear seat track bracket cover inner LH, rear seat track cover LH, rear seat track bracket cover outer, and the reclining hinge cover.

Install the shoulder anchor and floor end of the front seat outer belt assembly, both torqued to 42 N.m (428 kgf.cm, 31 ft.lbf), check if the ELR locks by pulling the belt quickly, and then reinstall all previously removed components.

Tape the screwdriver tip before using it to remove the shoulder anchor cover and the floor anchor cover.

Check the ELR lock by ensuring the belt locks when pulled out quickly.