Toyota 62170-0C030
Inflator Curtain, Passenger Side

A vehicle inspection of the Air Bag system becomes critical when a collision happens. Conduct a diagnostic system check on all vehicles that avoid collisions. A visual inspection of the curtain shield Air Bag assembly should be performed when installed to check if the front pillar garnish or roof headlining assembly shows any cuts or minor cracks or marks of discoloration. Any discovered defects require replacement of both assembly parts. Vehicles with deployed Air Bags after a collision need a diagnostic system check followed by assembly removal and connector inspection for damage and assessment of cuts, tears, cracks or discoloration on the assembly. Necessary replacements should be made. The examination procedure for the front passenger Air Bag assembly matches the previous steps starting from instrument panel inspection up to possible replacement of defective components. Check the steering wheel pad for mutilation or staining and verify that nothing impedes its operation with the wheel assembly. The SRS wire harness needs inspection for breakage and damaged connectors before the Air Bag control module along with sensors require replacement when showing deployment or damage. Visual assessments of the seat position sensor assembly together with the occupant classification ECU must be conducted before replacing components that show evidence of failure. To maintain side Air Bag sensors and seatback assemblies in safe condition it is essential to identify any observed cuts and cracks which demand replacement of defective components. Proper procedures for component removal and installation processes need to be strictly adhered to guarantee safety together with regulatory compliance.

Conduct repairs and inspections on the curtain shield airbag.

Connect the red clip to the battery positive (+) terminal and the black clip to the battery negative (-) terminal.