The proper tool to install the rear center seat inner belt assembly on the Hatchback LH Side is always the "Torx" socket wrench E10. When installing the rear center seat inner belt for the 60/40 Split Seat Type start by attaching the bolt according to a torque of 42 Nm (430 kgf-cm, 31 ft-lbf) while keeping the anchor plate clear from the convex areas on the rear seat back frame. Then you should insert the belt into both the band and the rear seat cushion. The "Torx" socket wrench E10 should be used to tighten the 3 bolts sequentially according to a torque of 37 Nm (375 kgf-cm, 27 ft-lbf). The rear center seat inner belt must be installed with its bolt secured to 42 Nm (430 kgf-cm, 31 ft-lbf) torque while ensuring forward facing orientation and preventing placement of the anchor plate on floor panel locating marks. Proceed with the installation of the No. 2 rear seat leg cover followed by the No. 1 cover before installing the rear seat cushion cover pad sub-assembly for the Hold Down Seat Type.