Other Name: Motor Assembly, Power Window Regulator; Power Window Motor, Front Left; Door Lock Actuator Motor; Motor; Motor Assembly, Power Window Regulator, Driver Side; Power Window Motor
Position: Driver Side
Replaces: 85720-0T010
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Fits the following Vehicles:
2009-2011 Toyota Venza | Base | 4 Cyl 2.7 L GAS, 6 Cyl 3.5 L GAS
Other Name: Motor Assembly, Power Window Regulator; Power Window Motor, Rear Right; Motor; Motor Assembly, Power Window Regulator, Passenger Side
Position: Passenger Side
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Fits the following Vehicles:
2009-2011 Toyota Venza | Base | 4 Cyl 2.7 L GAS, 6 Cyl 3.5 L GAS
Toyota Venza Window Motor
If you're thinking about purchasing OEM parts for your Toyota Venza, our website is your one-stop destination. We stock an extensive selection of genuine Toyota Venza Window Motor at pocket-friendly prices. Plus, we guarantee a swift delivery and a hassle-free return policy for your convenience.
Toyota Venza Window Motor Parts Questions & Experts Answers
Q: How to install the front Window Motor assembly on Toyota Venza?
A: The installation of the front power window regulator motor assembly needs the regulator arm positioned at a point under the intermediate location. fasten the motor assembly to its position using a "TORX" T25 driver by tightening three screws to 5.4 Nm which equals 55 kgf-cm or 48 in-lbf torque values. When installing a fresh front window regulator it will produce fresh installation slots with built-in screwholes. Begin installation of the front door window regulator assembly and after complete installation of the front door glass sub-assembly proceed to the front door service hole cover. Perform installation of the door side Air Bag Sensor combined with the front door inside handle sub-assembly as well as the front door trim board sub-assembly. The installation should include the courtesy light assembly together with the power window regulator master switch assembly and front door armrest base panel for the driver side as well as the power window regulator switch assembly mounted to the front door armrest base panel for the front passenger side. Next install the front door inside handle bezel plug and link its cable to the negative terminal of the battery before taking note of any systems that could demand a system reset after reconnection has been completed. To complete the process initialize the power window control system after checking the SRS warning light.