Other Name: Lamp Assembly, Dome; Dome Light, Center; Cargo Area Light; Dome Light, Rear; Dome Light; Interior Lights; Dome Lamp; Cargo Lamp; Dome Lamp Assembly; Lamp Assembly, Room
Position: Rear
Replaces: 81240-60060-B0
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Fits the following Vehicles:
2010-2015 Toyota Prius | Base, Five, Four, One, Persona Series, Three, Two | 4 Cyl 1.8 L FULL HYBRID EV-GAS (FHEV)
Other Name: Lamp Assembly, Dome; Dome Light; Interior Lights; Lamp Assembly, Room
Manufacturer Note: NEUTRAL BEIGE,TRIM4#
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Fits the following Vehicles:
2016-2022 Toyota Prius | 2020 Edition, Four, Four Touring, L Eco, LE, Limited, One, Three, Three Touring, Two, Two Eco, XLE | 4 Cyl 1.8 L FULL HYBRID EV-GAS (FHEV)
Other Name: Lamp Assembly, Dome; Dome Light; Interior Lights; Lamp Assembly, Room
Manufacturer Note: MD.CHARCOAL,TRIM9#
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Fits the following Vehicles:
2001-2003 Toyota Prius | Base | 4 Cyl 1.5 L FULL HYBRID EV-GAS (FHEV)
| Page 1 of 2 |Next >
1-20 of 34 Results
Toyota Prius Dome Light
If you're thinking about purchasing OEM parts for your Toyota Prius, our website is your one-stop destination. We stock an extensive selection of genuine Toyota Prius Dome Light at pocket-friendly prices. Plus, we guarantee a swift delivery and a hassle-free return policy for your convenience.
Toyota Prius Dome Light Parts Questions & Experts Answers
A: The service of dome lamp requires disconnecting the negative terminal cable first followed by a minimum 90-second wait to prevent Air Bag and seat belt pretensioner activation. Begin by uninstalling the room No. 1 light assembly which must be followed by bulb removal from the assembly. Begin the installation process by replacing the room No. 1 light bulb into the light fixture and afterward reinstall both the room No. 1 light assembly. The wiring connector must reattach to the negative battery terminal and then an initialization sequence must execute because systems may demand this procedure when reconnecting or disconnecting the cable.