Toyota 45100-60620-C1
Steering Wheel, Black

The first step to remove the steering wheel starts with steering the front wheels straight ahead followed by disconnecting the negative battery terminal cable and waiting 90 seconds for the SRS system to become disabled. Users must understand that particular systems need initialization before their systems reconnect after disconnection. The individual should first remove the lower No. 3 steering wheel cover before moving on to the lower No. 2 steering wheel cover. Begin by taking out the steering pad and then remove the steering pad switch assembly by unhooking its connector while also removing two screws and releasing four claws. The first step requires removal of the cruise control main switch through its connector separation and subsequent removal of the 2 screws. The assembly requires removal by disassociating it from the steering wheel set nut then keeping records of wheel position and main shaft location and using Special Service Tool: 09950-50013, 09951-05010, 09952-05010, 09953-05020, 09954-05011.

The installation of the steering wheel assembly requires matchmarks alignment between the steering wheel assembly and steering main shaft assembly before installing the wheel and tightening the set nut to 50 Nm (510 kgf-cm, 37 ft-lbf). Use the 2 screws to fasten the cruise control main switch and then link its connector. The installation of the steering pad switch assembly requires attachment of 4 claws followed by 2 screws and connector connection. Both steering pad and lower No. 2 and lower No. 3 steering wheel covers are installed afterward in the sequence described. After finishing these steps you must connect the cable to the negative battery terminal then check the SRS warning light within the diagnostic procedures.

Disconnect its connector and remove the 2 screws.

Attach the 4 claws, install the 2 screws, and connect the connector.