Toyota 53101-0E100
Grille Assembly, Front

The cool air intake duct seal requires removal of its 11 clips before processing further. Begin by taping up the radiator grille area before unbolting the 2 hardware pieces and subtracting the 4 clips which will release the 6 claws for guide disconnection to extract the radiator grille parts. The radiator grille emblem requires the removal of its 3 claws for extraction. Screw drivers should be used to remove 7 screws that allow 9 claw disengagement to remove the inside radiator grille if the vehicle has a plated moulding. The 4 claws that secure the upper radiator grille moulding on the left side should be disengaged to allow its removal while the right side follows the same method. The same procedure should be repeated for the center radiator grille moulding on both sides by dismantling 4 claws for each unit. The removal of the lower radiator grille moulding on the left side requires you to first disengage the four claws before conducting the same operations on the right side.

First engage the 4 claws for inserting the lower radiator grille moulding LH before you proceed to use the same steps for the lower radiator grille moulding RH. Follow the 4 claw attachment pattern to fasten the center radiator grille moulding LH and perform the same steps for the center radiator grille moulding RH. Move to the upper radiator grille moulding LH and operate 4 claws for installation while doing the same procedure for the upper radiator grille moulding RH. Secure the inside radiator grille through the 9 claws before screwing it with 7 screws. You must first insert the radiator grille emblem by attaching the 3 claws before you begin securing the radiator grille through 4 guides and 6 claws which need to be connected with 4 clips and 2 bolts. You must install the cool air intake duct seal by utilizing 11 clips.

Engage the 4 claws to install the center radiator grille moulding LH (w/ Plated Moulding).