Toyota 87931-0T021
Mirror Glass, Passenger Side

The first step to remove an outer rear view mirror requires disconnecting the negative battery cable followed by a 90-second wait period to deactivate the SRS system. The cable needs to be initialized before some systems will operate again after cable connection. The removal process begins by removing plugs from the front door inside handles followed by driver-side power window regulator master switches and passenger-side power window regulator switches which includes front door armrest base panels. The technician should proceed to remove the front door trim board sub-assembly along with the front door inside handle sub-assembly and the courtesy light assembly. The next removal steps include taking out the door side Air Bag sensor as well as the front door service hole cover. Detach the outer rear view mirror assembly by removing the hole plug followed by disconnecting the connector before unfastening three nuts until the claw disengages for complete removal of the assembly.

The installation of the outer rear view mirror assembly requires first using the claw to lock down 3 nuts which should be torqued to 8.0 Nm (82 kgf-cm, 71 in-lbf) before connecting the connector and installing the hole plug. You must put on the front door service hole cover followed by the door side Air Bag sensor and the front door inside handle sub-assembly. The procedure involves first installing the front door trim board sub-assembly followed by the courtesy light assembly along with the power window regulator master switch assembly which goes together with the front door armrest base panel for driver operations. The installation begins with positioning the power window regulator switch assembly to the front door armrest base panel along with the assembly followed by the front door inside handle bezel plug for the passenger side. When finished attach the cable to the negative battery terminal yet initialization following this step might be necessary for particular systems.