Toyota 56101-47141
Windshield, Front

Use Primer G on the windshield glass for No. 2 windshield glass stopper placement and let it dry for 3 minutes before disposing unused primer. Place two fresh stoppers on the windshield glass followed by installing two new stoppers onto the vehicle parts. Allow the Primer G to dry for 3 minutes on the glass surface where the window glass adhesive dam will be installed. Then stick the dam without peeling paper onto the glass near area A. Position the glass with suction cups and place matchmarks on both the glass and vehicle body. Before using old glass check if matchmarks are placed correctly. Wash the exposed body part with Primer M letting it dry 3 minutes then put Primer G on glass contact surface before throwing away leftover primer. Stick Toyota Genuine Windshield Glass Adhesive or an appropriate substitute onto the glass surface within the stated duration after cutting the cartridge nozzle. Place the glass onto the vehicle and put on each mark first. Gently push the glass edges toward the rim keeping a small opening between parts during the waiting time while tape holds the pieces until curing. Put Primer G on the glass area and wait to dry while aligning mounting marks that will guide the adhesive from drying. Following the waiting time move forward to put in cowl top ventilator louver pieces for right and left sides as well as all front wiper components and seal the hood to cowl top joint. After fitting the negative battery cable connect it to the battery's negative terminal then initialize system functions which need power-up.

Apply Primer M to the exposed part of the vehicle body and Primer G to the glass contact surface, then apply Toyota Genuine Windshield Glass Adhesive or equivalent to the glass.

Clean the windshield glass by scraping off damaged stoppers, dams, and adhesive, and clean the outer edges with white gasoline, avoiding contact with the glass surface afterward.

Clean and shape the contact surface, cutting away excess adhesive carefully, and clean the surface with a cleaner, ensuring it is free of any adhesive residue.

Begin by removing the roof headlining assembly, which involves taking off various trim pieces and partially lowering the roof headlining.