Toyota 48812-21030
Stabilizer Bar, Rear

The installation of the rear sway bar kit begins by securing the two sway bar bushes onto the sway bar kit following rules where place the bush at the outer stopper ring side with facing toward the internal part of the vehicle. Use the 2 bolts and 2 nuts to install the sway bar kit and its 2 No. 3 sway bar brackets until they reach a torque of 35 Nm (357 kgf-cm, 26 ft-lbf). Follow the below instructions to install the sway bar link LH on the left-hand side with 2 nuts: torque them at 44 Nm (49 kgf-cm, 32 ft-lbf). During this step if the ball joint rotates while tightening the nut secure the stud using a 5 mm hexagon wrench. Perform these installation steps on the right-hand side rear sway bar link assembly as well. Check the rear wheel alignment and perform necessary adjustments at the end of the procedure.

The first step to remove the rear sway bar kit is to detach the left-hand side rear sway bar link assembly by unscrewing its 2 sway bar link nuts and sway bar link and retaining the ball joint from turning with a 5 mm hexagon wrench on the stud. The same removal steps should be executed for the sway bar link assembly on the right-hand side rear. The procedure starts with removing the rear sway bar kit where you need to detach two bolts and two nuts along with two No. 3 sway bar brackets on the suspension member and finish by taking out the two sway bar bushes from the sway bar kit.

Disconnect the tie rod end sub-assemblies and the pressure feed tube assembly.

Inspect and adjust the rear wheel alignment as necessary.

Begin by placing the front wheel straight ahead and removing the column hole cover silencer sheet.

Install the stabilizer bar along with the 2 No. 3 stabilizer bar brackets using the 2 bolts and 2 nuts, tightening to a torque of 35 Nm (357 kgf-cm, 26 ft. lbs.).

Use a 5 mm hexagon wrench to hold the stud.

Install with 2 nuts, torqued to 74 Nm (755 kgf-cm, 55 ft. lbs.).